TenTec
[Top] [All Lists]

Re: [TenTec] Frozen display on Omni V.9

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Frozen display on Omni V.9
From: "Mike Brown" <mike@k9mi.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 1 Aug 2007 14:05:50 -0000
List-post: <mailto:tentec@contesting.com>
Is there any Ten Tec service department in Europe?
If not call Ten Tec here in the states. They should give you a place to 
start looking anyway.

73, Mike
----- Original Message ----- 
From: "Bob Towers" <mm0rkt@beeb.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, July 29, 2007 10:34
Subject: [TenTec] Frozen display on Omni V.9


>I have noticed in the last month or so that the display on my Omni V.9
> freezes up after about 20 minutes operation. Recently it has got worse
> and the display is frozen when I switch on the rig. Rotation of the
> tuning control does nothing except change the last digit on the display
> by +/- 1 (=100Hz). All other controls work correctly.
>
> I am able to tune the rig using CAT control, by the way. Disconnection
> of the CAT serial link makes no difference.
>
> Any help on this would be much appreciated.
>
> 73 and thanks in advance
>
> Bob Towers
> MM0RKT
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>