[Top] [All Lists]

Re: [TenTec] AL-811 amp integration with Omni V

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] AL-811 amp integration with Omni V
From: rickdenney <rick@rickdenney.com>
Reply-to: Rick Denney <rwd@iteris.com>,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 3 Aug 2007 22:28:35 -0400
List-post: <mailto:tentec@contesting.com>
OTAKEBI@aol.com writes...

> Mark, he tried that and says it does not key the amp.
> I told Rick that the Relay(N O) RCA is the one I use.
> He may have a bad RCA plug, phono cable, or someone without an amp  disabled
> the relay because it made tooooo much noise.
> Dan/N4VET

Thanks to all. I believe the relay is operational--I hear it clicking,
though it makes so little noise that I wonder that it bothered anyone.
But I'll pull the covers again and remove the cover from the relay and
check it. I suspect it's the RCA jack that's the problem--I'll switch
this one with another one that I'm less likely to use. If not, I'll
see if I can troubleshoot the circuit--the control board seems pretty

Rick, KR9D

Richard W. Denney, Jr. PE|Iteris, Inc.
Associate Vice President |107 Carpenter Dr. Ste 230 |    703.925.3819
rwd@iteris.com           |Sterling, VA 20164        |Fax 703.471.1757

TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>