I do believe in that era the little plugs were not soldered onto the
interconnecting board wires but just pushed into the connectors. DANGEROUS !
Some times they need to be pushed on very gently with a very small screw
driver. We used to have back plane troubles in the rear of T carrier panels
at the telephone company and some times that was the fix. Be careful, this
can get DANGEROUS ! You can cause more trouble than you clear if you are NOT
Walt K8CV Royal Oak, MI.
----- Original Message -----
From: "Ken Brown" <email@example.com>
To: "Discussion of Ten-Tec Equipment" <firstname.lastname@example.org>
Sent: Wednesday, August 08, 2007 1:44 AM
Subject: Re: [TenTec] Paragon problem
>> The number keypad will not do anything. The filters (all are installed)
>> is stuck on 2.4.
> On my Paragon the filter selection keys are blue. Mine is a Paragon II
> though. If all my blue keys worked, it would not be stuck on 2.4 kHz.
>> The mode is stuck on LSB. RX offset does not work, but TX offset does.
>> All the "blue" keys work. All the knobs function. The VFO works, and the
>> RX seems to be fine and the TX works, too. I tried the reset button on
>> the right side to no avail and made sure I had not done a global lock. Of
>> all the black buttons around the VFO knob, only the "fast" button works.
>> Any ideas??
> Look at the schematics and see what is common to most of the keys that
> do not work. I suspect that a bunch of the keys are connected in a
> matrix, like in the Paragon II, where 44 keys are in a 4 X 11 matrix.
> That way it only requires 15 wires from the board the keys are on to the
> logic or other board that they connect to, instead of 45 wires. And
> there are other keys which are not really part of a matrix and have
> individual leads to each key. The keys in the matrix are probably stuck
> and the non-matrixed keys still work. If that is the case, then you have
> to find out what is the fault in the matrixed keys, something like a
> stuck key locking up the whole matrix scanning scheme, or a bad chip.
> I'll bet if you just get inside an clean and exercise connectors the
> problem will go away.
> DE N6KB
> TenTec mailing list
TenTec mailing list