[Top] [All Lists]

Re: [TenTec] frozen display

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] frozen display
From: Bob Towers <mm0rkt@beeb.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 08 Aug 2007 16:06:59 +0100
List-post: <mailto:tentec@contesting.com>
Paul DeWitte K9OT wrote:
> Bob, I had a simalar problem a few years ago with my Omni VI+.
> I was told that it might be dirty connectors and you could check it out by
> switching with the rit. I dont remember the numbers on the wires but that
> was not the problem anyway. The problem was a dirty connector where it went
> onto the encoder.
> Took it off and cleaned it and has been working FB ever since. That tip was
> from Dave,K1FK. It saved me from buying a new encoder.
> Good luck
> 73 Paul K9OT
> _______________________________________________
> Could anybody give me instructions on how to get the keypad panel off 
the fascia plate of my Omni V? I need to replace the digital encoder. I 
think the connector is 93.

I see there's a screw in each corner of the front panel. Undoing them 
presumably releases the front panel. Does the key pad panel then come 
loose at the same time?


TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>