Bob if you go to my website (link below) and open the Omni V.9 document
there's a blow by blow set of instructions to remove the keypad. It's in
the 2nd part of the document after the description of the Omni V.9 mod.
To: Discussion of Ten-Tec Equipment <email@example.com>
Subject: Re: [TenTec] frozen display
From: Bob Towers <firstname.lastname@example.org>
Reply-to: Discussion of Ten-Tec Equipment <email@example.com>
Date: Wed, 08 Aug 2007 16:06:59 +0100
Could anybody give me instructions on how to get the keypad panel off
the fascia plate of my Omni V? I need to replace the digital encoder. I
think the connector is 93.
I see there's a screw in each corner of the front panel. Undoing them
presumably releases the front panel. Does the key pad panel then come
loose at the same time?
TenTec mailing list