[Top] [All Lists]

[TenTec] Firmware update

To: tentec@contesting.com
Subject: [TenTec] Firmware update
From: Bill Ogden <wogden@attglobal.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 10 Aug 2007 10:36:48 -0400
List-post: <mailto:tentec@contesting.com>
It has been a while since I updated my Orion I.  I am now installing the 062a 
level. I seem to remember that the update process stepped through about 9000 
data lines fairly rapidly the last time I did this.
The current update is moving very slowly. It stayed on lines 680, 710, and 720 
for several minutes each. (I may not have remembered the line numbers 
correctly.) The Orion display says "Program Flash 668" when the PC display is 
much past this number.  Also, the Orion display says "CC=000" (I assume this is 
Condition Code 0, usually a good sign for a computer program).

Is this update proceeding normally?

Bill - W2WO
TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>