[Top] [All Lists]

Re: [TenTec] frozen display

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] frozen display
From: Bob Towers <mm0rkt@beeb.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 12 Aug 2007 20:04:21 +0100
List-post: <mailto:tentec@contesting.com>
Rick Williams wrote:
> Bob if you go to my website (link below) and open the Omni V.9 document
> there's a blow by blow set of instructions to remove the keypad.  It's in
> the 2nd part of the document after the description of the Omni V.9 mod.
> 73, 
> Rick 
>The new digital encoder arrived yesterday from TenTec and I installed it 
today. It seems to have done the trick.

The replacement was pretty straightforward, following Rick's lead about 
the second part of the Omni V.9 instructions.

The only tricky bit was getting all the sockets back on to the plugs on 
the keypad board, especially no 95 which is just below the display. 
There's 6 pins on the board and 5 on the connector so, if you're going 
to attempt the replacement, make sure you mark which is the spare pin 
before you take off the front panel.

Many thanks again for all your help,



TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>