(I use one of these since 2001)
Works well on PCI buss under Windows, 4 additional serial ports share one
Also available with 1, 2, 6 and 8 ports as well as Parallel Port cards.
(With the serial port on my mainboard and the Byterunner 4 port add on card,
I have six total active serial ports for control of two rigs, both with CW
keying, PTT for PSK31, KAMPlus for RTTY and other digital modes, DCU-1
Rotator control, and PCI Modem.)
Plug n Pray, Never had any problem/s, a clean and simple + inexpensive
----- Original Message -----
From: "Mike Bryce" <firstname.lastname@example.org>
To: "Discussion of Ten-Tec Equipment" <TenTec@contesting.com>
Sent: Tuesday, August 21, 2007 6:46 PM
Subject: [TenTec] controlling more than one ten tec radio with one computer
> I have at last got a computer in the shack.. yea, I know... way to long
> but that being said, there's only one serial port on this used
> machine. (sister gave it to me. It's running windows ME..)
> Now, is it possible to get a serial port to usb device for each and
> every rig I have now, then plug the usb cables into a usb hub and
> select the one that I want?
> I would like to run the argonaut 5, the jupiter, and the RX320 all
> from the same computer and not have to keep swapping out the single
> serial port cable I have.
> Can this be done or am I in deep do...
> Mike, WB8VGE
> SunLight Energy Systems
> The Heathkit Shop
> J e e p
> Note: No trees were killed in the sending of this message, but a
> large number of electrons were terribly inconvenienced
> TenTec mailing list
TenTec mailing list