[Top] [All Lists]

Re: [TenTec] Argo V Serial Port

To: <tentec@contesting.com>
Subject: Re: [TenTec] Argo V Serial Port
From: "Chip Morgan" <wmorgan@outdrs.net>
Reply-to: wmorgan@ieee.org,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 27 Aug 2007 01:30:03 -0400
List-post: <mailto:tentec@contesting.com>

I had the same problem and Ten-Tec sent out a new connector; however, when I
started to take the rig apart to replace the connector I found the shell of
the DB-9 was a seperate piece.  So just remove the jack screw posts from the
connector and whatever else holds that board to the rear panel and reverse
the shell of the DB-9.  Re-assemble and you're done.  Took all of about 5
minutes when I figured out what happened.


Chip N3IW

TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>