The use of external audio equalization doesn't necessarily mean
someone is looking for a wide audio bandwidth. They might just want to
adjust the voice response over the 2.4Khz bandwidth. There are a heck
of a lot of microphones in use that could use such equalization to
make the op's voice sound more natural at the receiving end.
73,
Barry N1EU
On 11/1/07, Bob McGraw - K4TAX <RMcGraw@blomand.net> wrote:
> Rob knows of what he speaks. Take his suggestions. Trying to cram
> additional audio bandwidth through the TX filter system is basically asking
> for problems. The 300 Hz - 2.7 kHz limits provides a 2.4 kHz bandwidth.
>
> 73
> Bob, K4TAX
>
> ----- Original Message -----
> From: "Rob Atkinson" <ranchorobbo@gmail.com>
> To: <tentec@contesting.com>
> Sent: Thursday, November 01, 2007 6:49 PM
> Subject: Re: [TenTec] Anyone using W2ihy products on omni 6 with
> goodresults?
>
>
> > That might be okay for the Orion 2 but for a stock Omni 6, I don't
> > think much of anything extra is needed at all. Here's why: the rig's
> > tx bandwidth is roughly from around 300 hz up to 2.7 Khz. If it is
> > properly alligned, and used with a compatible mic, it should have good
> > punchy dx rig type audio. Anything that's boosted by an outboard box,
> > will probably get filtered out by the rig's IF filter or buckshot. To
> > me, It, along with the Corsairs and Tritons and other earlier analog
> > TT rigs are best off following the "less is more" rule. Just run a
> > mic into it, adjust the power and mic gain pots and call it a day.
> >
> > Another reason is that the Omni 6 has no tx monitor circuit. The one
> > in the W2IHY eq should definitely not be relied on because it does not
> > tell you how it sounds out of the rig on the air. You need a
> > separate rx for that.
> >
> > 73
> >
> > rob / k5uj
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|