TenTec
[Top] [All Lists]

Re: [TenTec] Line Level audio output of Omni VI+ vs Argo V???

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Line Level audio output of Omni VI+ vs Argo V???
From: "Bob McGraw - K4TAX" <RMcGraw@Blomand.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 4 Nov 2007 18:27:16 -0600
List-post: <mailto:tentec@contesting.com>
It just may be that the "low level" input required of the RTTY device is 
actually a "low impedance" input as well, thus loading the line output of 
the Omni VI Plus.  The HP output is really a pretty low Z and thus not 
loaded by the low impedance of the RTTY device.

73
Bob, K4TAX


----- Original Message ----- 
From: "Duane Calvin" <ac5aa1@gmail.com>
To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Sent: Sunday, November 04, 2007 6:16 PM
Subject: Re: [TenTec] Line Level audio output of Omni VI+ vs Argo V???


> Dave -
> I can't tell you the comparative output of the VI+ vs the Argo, but
> I can tell you that running the audio out (line level) from the VI+ in my
> shack was more than sufficient to drive an HAL DXP38 and a KAM-Plus very
> successfully.
>
> 73, Duane
>
> Duane Calvin, AC5AA
> Austin, Texas
> www.ac5aa.com
>
>
> -----Original Message-----
> From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
> On Behalf Of Dave Edwards
> Sent: Sunday, November 04, 2007 6:01 PM
> To: tentec@contesting.com
> Subject: [TenTec] Line Level audio output of Omni VI+ vs Argo V???
>
> Can anyone shed some light on this subject?
> I'm playing around with an old RTTY gizmo that needs low level audio fed
> into it.
>
> I used the Ten Tec sound card cable for my Argo V, and it works like a
> champ.
> I tried the line level audio output jack on the Omni VI+, and no decoding 
> at
>
> all!
> It works fine when I plug in to the headphone jack.
>
> Without busting out the scope, can anyone tell me....is the line output of
> the Argo significantly more signal than that of the Omni VI+??
>
> I'm thinking it HAS to be...or else my Omni is bustimicated!!!
>
> Thanks for any "input"!
>
> ....Dave
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>