TenTec
[Top] [All Lists]

Re: [TenTec] Cyberpower 3000 rif

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Cyberpower 3000 rif
From: "mcelmer1" <mcelmer1@netecin.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 5 Dec 2007 09:15:55 -0700
List-post: <mailto:tentec@contesting.com>
I suggest connecting the grounds together so they will be at the same 
potential.  I don't expect this to solve the problem but it's worth a shot.

Mike
W8TRN
----- Original Message ----- 
From: "Denton" <denton@oregontrail.net>
To: "Carl Moreschi" <n4py@arrl.net>; "Discussion of Ten-Tec Equipment" 
<tentec@contesting.com>
Sent: Wednesday, December 05, 2007 8:46 AM
Subject: [TenTec] Cyberpower 3000 rif


> Have a station consisting of a TT omni vi and vii.....have an rfi 
> problem...
> I have a Cyberpower PR 3000 sine wave ouput, commmercial grade
> uninteruptable power supply that is located in my basement with the case
> grounded to an 8 ft ground rod going thru the basement wall. The input to
> the ups is on an individual circut.
> Output via the ups 30 amp 120 vac goes to the radio station on the main
> floor, which shares an outlet with the radio station's power supplies and
> the pc.
> Battery pack for the Cyberpower is homebrew using two gangs of 4 38 amp 
> hour
> gas absorption mat batteries wired in series to satisfy the ups 48 vdc
> requirement.
> I notice there is considerable rfi comming from the ups when it is active.
> The ups is supposed to be emi/rfi filtered and has an isolation 
> transformer
> on the ups output. Scoping the output of the ups indicates a so called 
> clean
> ac sine wave. Testing of the ac line input and output of the usp indicates
> correct wiring.
> Clamp on ferrite chokes on the ac output of the ups has little effect.
> I would like to get rid of the rfi into the radio station. Rfi is most
> prevalent on 40 thru 20 meters..the other bands seem to be uneffected.
> Radio station is heavly grounded on its own ground rod system, not 
> directly
> connected to the ups.
> I could run the hf transcievers on a dedicated circut with a
> powersupply--blocking diode---battery pack, but would much prefer to keep 
> it
> all on the same power source.
> Any ideas? Thanks....
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>