[Top] [All Lists]

Re: [TenTec] Insertion loss

To: tentec@contesting.com
Subject: Re: [TenTec] Insertion loss
From: K5XS@aol.com
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 22 Dec 2007 16:57:55 EST
List-post: <mailto:tentec@contesting.com>
Assuming they are press-in, you might check for oxidation on the  
pins/sockets.  (But you've likely already done that...)
Aside from that, I'd wonder if it worked okay in your friend's rig.
Best of luck.
In a message dated 12/22/2007 2:43:45 P.M. Central Standard Time,  
jim-g4ppg@blueyonder.co.uk writes:

Recently  I acquired a 500 Hz cw filter from a friend who was parting
with corsair 2  to a fone operator
I fitted this filter to my  Corsair as per the  instruction in the
manual, the results have been disappointing
I find  that when I switch in the 500hz filter  an S9 signal will drop
to as  low as S1 any help in resolving 
This  problem would be most welcome  .

Thanks 73 Jim G4PPG

**************************************See AOL's top rated recipes 
TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>