The pegasus file interface will only work when using my N4PY software along
with logic8. If you just want to use logic8 without my N4PY software, then
setup logic8 for a Jupiter. The Jupiter front panel serial commands and
Omni VII front panel serial commands are the same.
Carl Moreschi N4PY
121 Little Bell Drive
Hays, North Carolina 28635
----- Original Message -----
From: "NZ8J" <email@example.com>
Sent: Sunday, December 23, 2007 9:33 AM
Subject: [TenTec] Omni VII and Logic 8
> I am trying to interface Logic 8 to my Ten Tec Omni VII and just can't
> seem to make it happen. There is no specific "Omni VII" option to pick
> from, I've been told to use the Pegasus interface file. I pick that one
> out of the list, set up the parameters, but I always get an error that
> says "mismatch" or some other equally mystifying message. It locks up
> Logic and it takes a bit to get it going again. I'd like to hear from
> anyone who has used Logic with an Omni VII.
> I've been able to interface Logic with just all the other rigs I've had
> here successfully, however this one is giving me a problem.
> Any help would be appreciated.
> TenTec mailing list
TenTec mailing list