The Triton relies upon the ALC voltage's being generated to prevent
oscillation in the final amplifier. The diodes which generate this voltage
sometimes go bad -- often from a lightning storm in the next county. When
this is the problem, the rig will work at lower power settings but once the
drive is advanced beyond a certain point the oscillation starts. That will
give a higher reflected power reading and excessive current.
If that is the trouble, I suggest replacing not only those diodes but also
the SWR detection diodes since they are in physical proximity and sometimes
fail at the same time.
73, Mike N4NT
----- Original Message -----
From: "Louis Ciotti (KC2RVD)" <email@example.com>
Sent: Wednesday, December 26, 2007 4:56 PM
Subject: [TenTec] Triton IV with digital modes
>I have been using my Triton IV with PSK31 and RTTY over the past few weeks,
> and occasionally something odd happens.
> I tun up the radio/antenna for about 1:1 using the lock position. When I
> to transmit using rtty/psk31 I will get a very high SWR reading on the
> Triton meter, and I get a weird buzzing noise coming from the 262G power
> supply. I think the rig may be going into oscillation, but have no way to
> verify this. Anyone else experience this?? I have been able to make some
> digital contact with good signal reports, but it this is with the drive
> turned way down.
TenTec mailing list