[Top] [All Lists]

Re: [TenTec] OMNI6 PLUS Alignment procedure needed

To: tentec@contesting.com
Subject: Re: [TenTec] OMNI6 PLUS Alignment procedure needed
From: "Rob Atkinson" <ranchorobbo@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 28 Dec 2007 17:57:18 -0600
List-post: <mailto:tentec@contesting.com>
Warning:  In the Omni 6 manual, there are a couple of errors in the
designators for some trimmer caps that adjust things like the carrier set
point and the cw tx frequency (so it is on the display frequency).  I do not
recall the details but I think there are earllier messages in the reflector
archive that correct these errors in the manual.  Search them out before you
try to allign the rig.  I did not know the manual had errors until after
trying to do an allignment on mine and the result is that I got a few things
out of adjustment.  I was lucky in that I didn't mess up any of the cw
adjustments and I use the Omni 6 for cw.


rob / k5uj
TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>