[Top] [All Lists]

Re: [TenTec] OMNI6 PLUS Alignment procedure needed

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] OMNI6 PLUS Alignment procedure needed
From: "Bob McGraw - K4TAX" <RMcGraw@Blomand.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 29 Dec 2007 19:34:03 -0600
List-post: <mailto:tentec@contesting.com>
I too am puzzled.  The manuals that I have received from Tentec with the 
equipment that I purchased has a written circuit description, a schematic, 
and a component layout.  And where appropriate, a written alignment 

If you don't have a manual, they are available for purchase from Tentec. 
When I sold my equipment, also supplied, to the buyer, the manual that came 
with the equipment.  It often contained my pencil notes, thus they can be 
easily erased, and figures from my operational or alignment notes or 
performance data.

What's missing?

Bob,. K4TAX

----- Original Message ----- 
From: "John Cox" <jecox@tri-lakes.net>
To: <wb2vuf@arrl.net>; "Discussion of Ten-Tec Equipment" 
Sent: Saturday, December 29, 2007 10:03 AM
Subject: Re: [TenTec] OMNI6 PLUS Alignment procedure needed

>I have an Omni 6 and an Omni 6+ and the manuals seem to be pretty detailed
> to me.  Most of the manual is devoted to descriptions of componets and
> service information.
> What is it that I am missing here?  I would think that with the 
> information
> supplied that any person with an electronics back ground could service 
> them.

TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>