| To: | aluscre@neo.rr.com,Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] 3D spreadsheet |
| From: | aluscre <aluscre@neo.rr.com> |
| Reply-to: | aluscre@neo.rr.com,Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Tue, 01 Jan 2008 15:04:57 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
|
Sorry, message was sent to wrong mailing list. -- |--------------------------| Anthony A. Luscre K8ZT Stow, Ohio |--------------------------| _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] 3D spreadsheet, aluscre |
|---|---|
| Next by Date: | Re: [TenTec] OMNI6 PLUS Alignment procedure needed, Ken Brown |
| Previous by Thread: | Re: [TenTec] 3D spreadsheet, aluscre |
| Next by Thread: | Re: [TenTec] 962 Power supply Bridge rectifier needed, Lew |
| Indexes: | [Date] [Thread] [Top] [All Lists] |