I don't think there's really a need to do an end-to-end alignment.
Experience with my Paragon, purchased new in 1991, is that the only
things that goes out of alignment are the crystal oscillators, due to
crystal aging and oxidation of the trimmer caps. The manual tells how to
align the BFO frequencies. It doesn't give specific instructions on the
PBT oscillator, but its easy to figure this out from the circuit
description. I would not attempt to align passband filters, because I
don't have a sweep generator.
73,
Bob WB2VUF
Bob McGraw - K4TAX wrote:
> I too am puzzled. The manuals that I have received from Tentec with the
> equipment that I purchased has a written circuit description, a schematic,
> and a component layout. And where appropriate, a written alignment
> procedure.
>
> If you don't have a manual, they are available for purchase from Tentec.
> When I sold my equipment, also supplied, to the buyer, the manual that came
> with the equipment. It often contained my pencil notes, thus they can be
> easily erased, and figures from my operational or alignment notes or
> performance data.
>
> What's missing?
>
> 73
> Bob,. K4TAX
>
>
> ----- Original Message -----
> From: "John Cox" <jecox@tri-lakes.net>
> To: <wb2vuf@arrl.net>; "Discussion of Ten-Tec Equipment"
> <tentec@contesting.com>
> Sent: Saturday, December 29, 2007 10:03 AM
> Subject: Re: [TenTec] OMNI6 PLUS Alignment procedure needed
>
>
>> I have an Omni 6 and an Omni 6+ and the manuals seem to be pretty detailed
>> to me. Most of the manual is devoted to descriptions of componets and
>> service information.
>> What is it that I am missing here? I would think that with the
>> information
>> supplied that any person with an electronics back ground could service
>> them.
>>
>>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|