TenTec
[Top] [All Lists]

Re: [TenTec] Coax Connectors

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Coax Connectors
From: Ken Brown <ken.d.brown@hawaiiantel.net>
Reply-to: ken.d.brown@hawaiiantel.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 31 May 2008 10:19:40 -1000
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
>
> Wonder what you think of the TNC, seem to be used a lot in the labs, together 
> with BNC and N.
>
>
>   
BNC, TNC and N connectors are identical on the inside. That is, the 
center "hot lead" pin and the outer shield fingers are the same 
dimensions. You can plug a N male connector into a BNC female connector 
and make a proper connection, though there is nothing to hold it in 
place. The only difference between the three types is the outer "hold it 
together" mechanisms, and in the case of N that also serves as a weather 
seal. Beware however that there are 50 ohm and 75 versions of all of 
them, and they should not be connected to one another. Damage to the 
center conductor female part will result. There may be other impedance 
versions too. The non 50 ohm versions are much more common in BNC and 
TNC than they are in N.

Also there is MHV which looks very much like a BNC, yet has the 
dielectric extending out further in front on the male connector. Don't 
try to plug a MHV male into a BNC female. You will not get the bayonet 
turned and latched. MHV is typically used for low current, high voltage 
supply to photomultiplier tubes and vacuum gauges.

I like to use N connectors for cables with transmit power on them and 
BNC for receive only connections. This results in quality constant 
impedance connections for both, and an easy way to avoid getting them 
mixed up.

DE N6KB

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>