Did you do the battery reset? You power off, press and hold the VFO B LCK
button, power on, and continue holding it until the radio says "battery
failure".
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "Tõnno Vähk" <Tonno.Vahk@gildbankers.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, July 30, 2008 4:06 PM
Subject: [TenTec] ORION II TX gone
Hi, I have lost any TX output from OII. Pwer can be turned up to 100w but
no TX out in any mode, everything else seems normal. RX seems to be OK. I
saw some messages in archives looking for solution to the same issue but
no cure. Tried Master reset and also reinstalled firmware, no change. Is
there anything I can try or should I send it to repairs?? Has it been
established what the problem is?
73
tonno
es5tv
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|