[Top] [All Lists]

Re: [TenTec] ORION II TX gone

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] ORION II TX gone
From: "Barry N1EU" <barry.n1eu@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 30 Jul 2008 21:20:04 +0000
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Do you have the keying loops turned off and the Transmitter turned on
in the TX Menu?

Barry N1EU

On Wed, Jul 30, 2008 at 8:06 PM, Tõnno Vähk <Tonno.Vahk@gildbankers.com> wrote:
> Hi, I have lost any TX output from OII. Pwer can be turned up to 100w but no 
> TX out in any mode, everything else seems normal. RX seems to be OK. I saw 
> some messages in archives looking for solution to the same issue but no cure. 
> Tried Master reset and also reinstalled firmware, no change. Is there 
> anything I can try or should I send it to repairs?? Has it been established 
> what the problem is?
TenTec mailing list
<Prev in Thread] Current Thread [Next in Thread>