Connect the 12 volt power supply to an RCA plug, via a switch.
On and off when you want. No mods to the unit.
73 de Gary, AA2IZ
----- Original Message -----
From: "David Cuttler" <davidcuttler@yahoo.com>
To: <tentec@contesting.com>
Sent: Wednesday, August 13, 2008 12:17 PM
Subject: [TenTec] 229A Tuner question
I just acquired a 229A tuner, and I can see that I will have an issue
regarding the panel lights. If I use an RCA plugged cable to my Corsair II
everything will be fine. The panel lights will be on when the Corsair II is
on. Here is where it gets sticky. If I want to use some other hf rigs, It
will require leaving the Corsair II on all the time just to power the panel
lights.
I thought about hooking the tuner up to a wall wart, and just leaving it on
all the time, but that will shorten the bulb life, and also consume power 24
hours a day at a time when everyone should be conserving power.
I am about to drill two holes next to the RCA socket, and install a modern
socket in parrallel to match the common plug used on most of the 12V wall
warts, leave the tuner powered up from the wall wart and also install a push
button switch to turn the panel lights on when required. I do not have a
problem modifying my stuff, because I am not saving it for the next
collector.
If someone has a better idea, I am all ears.
David Cuttler – KE6YX
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|