[Top] [All Lists]

Re: [TenTec] Replacing the speaker in a Delta II/Argonaut II

To: <tentec@contesting.com>
Subject: Re: [TenTec] Replacing the speaker in a Delta II/Argonaut II
From: "Bill Acito W1PA" <w1pa@hotmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 3 Oct 2008 15:03:36 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
re: external jack

I will take a look.... thank you for the suggestion. It would make sense 
the internal speaker still works.

I agree that an external speaker does sound better, but if I ever 
decide to sell it, I would prefer it be 100% (I have already 
found and replaced the blue EL backlight.)

Bill W1PA

From: Bill Acito W1PA 
Sent: Friday, October 03, 2008 12:45 PM
To: tentec@contesting.com 
Subject: Replacing the speaker in a Delta II/Argonaut II

I have a Delta II that I am refurbing, and it appears that the internal speaker 
some sort of issue or short. After a few minutes the audio gets very distorted, 
the audio amp module gets very hot. An external speaker plugged into the 
jack works fine, and the module stays cool.

In looking at the how the rig's aluminum frame is put together, it looks like I 
have to 
completely disassemble the radio to get access to the screws that hold the 
speak in place.

Has anyone ever done this replacement, and if so, is there an easier way?

TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>