[Top] [All Lists]

[TenTec] Jupiter fimware Rev 1.30

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: [TenTec] Jupiter fimware Rev 1.30
From: Henry Mackey <kb9cqo@embarqmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 26 Oct 2008 14:39:18 -0400 (EDT)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Would the group please lend a hand in upgrading the Jupiter? If there is a way 
to be confused in handling anything it seems my bad luck lately to find that 

The 538KBD.RUF file was used to upgrade the rigs firmware. Following this the 
chip received from TenTec was installed replacing the previous chip. The screen 
now states, upon recycling the power, "Rev 1.30 b3 08.21.2008".

I am going to skip how I understood, or misunderstood, the instructions 
following this point. The power was cycled, but I see no difference in the new 

What am I to do with the disc that came with the chip from TenTec? I see no 
instruction concerning this disk either in the box or in the software 
instructions received via the web.

73 de Henry/n9hm
TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>