TenTec
[Top] [All Lists]

Re: [TenTec] Ground, noise blankers in the Omni V and plasma TV's

To: "tentec@contesting.com" <tentec@contesting.com>
Subject: Re: [TenTec] Ground, noise blankers in the Omni V and plasma TV's
From: "Jim Brown K9YC" <k9yc@audiosystemsgroup.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 19 Jan 2009 09:39:04 -0800
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
On Sun, 18 Jan 2009 17:54:16 -0500, Scott Sheppard wrote:

>Dealing with some very bad RFI from my plasma TV (Panasonic).Have
>improved my ground to no avail (I honestly did'nt think it would do
>anything anyway--in fact it stays the same with no ground at all).

All products are different -- they have their own ways of radiating 
trash depending on how they are built. If the dominant mechanism is 
direct radiation from the screen, as K4TAX has described, you're 
hosed -- there's nothing you can do but turn it off or dispose of 
it. 

IF, however, the trash is radiated common mode by cable attached to 
the set (that is, that wiring is an antenna), you can make a MAJOR 
dent in the noise with a common mode choke. The tutorial below 
explains these mechanisms and describes how to kill them.   

http://audiosystemsgroup.com/RFI-Ham.pdf

73,

Jim Brown K9YC 



_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>