Ken -
It never happened with my Paragon II. Is the noise you are experiencing
still there when you pull the RS232 Interface Card? Maybe just needs
reinstallation to see if the card connector needs cleaning. A bad ground
perhaps? Or a poor connection at the cabinet rear connector?
Don, ve1bn@eastlink.ca
----- Original Message -----
From: "Ken Brown" <ken.d.brown@hawaiiantel.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, January 23, 2009 2:40 AM
Subject: [TenTec] Paragon II RS-232 noise
>I hooked up the serial data port on my Paragon II to my computer for
> logging of the frequency. There is a buzzing noise in the
> speaker/headphones with every data string. The volume of the noise does
> not depend on the band in use, whether an antenna or a terminator is
> connected, the mode or band. The only controls on the rig that do affect
> the noise are the audio gain and the tone controls. Seems like the noise
> is getting into the audio stages, maybe through a power supply common to
> both the RS-232 board and the audio stages. Have any of you experienced
> anything like this with a Paragon or Paragon II? It never happened with
> my Omni VI.
>
> DE N6KB
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
--
I am using the free version of SPAMfighter.
We are a community of 5.9 million users fighting spam.
SPAMfighter has removed 53 of my spam emails to date.
Get the free SPAMfighter here: http://www.spamfighter.com/len
The Professional version does not have this message
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|