I also notice the anomaly when AF AGC is engaged.
If the decay rate is set to less than 6 dB/s the AGC hangs for the
prescribed period, but the decay rate acts as if it's essentially
infinity. This results in severe audio distortion with many pops.
My O II has been on all day and I have NOT seen the anomaly described
for the spectrum display. What I *did* notice is a tiny horizontal
red "dash," about 1 mm long, that appeared at the same vertical level
as the filter width display, roughly above the blue spectrum tuning index.
While I'm sure that this list is monitored by TT, because this is
listed as a beta release, is there a conduit for bug reports like
this? I don't mean feature requests, such as "Make the blue tuning
index a vertical line," etc., but true buggy behavior, like odd lines
appearing on the spectrum display and strange behavior by the AF AGC.
Kim Elmore, N5OP
At 02:49 PM 2/27/2009, you wrote:
Linwood Davis skrev:
> 2.041 Users,
>
> Set O2 for AF AGC.
>
> Then try setting the AGC to SLOW or PROG, then go into the RX
menu and turn the decay rate to less 6dB/s.
>
> I found that severe distortion occurs.
>
> Further, a decay rate of 6 and 7 dB/s causes the decay rate to go
to 0; it won't ever decay.
>
> Does this occur when you folks try it?
>
> Lin
> WB1AIW
>
Not here Lin, behaves exactly as expected under the conditions described....
I'm happy so far :-)
--
Vy 73 de OZ1PIF/5Q2M, Peter
** CW: Who? Me? You must be joking!! **
email: peter(no-spam-filler)@frenning.dk
http://www.frenning.dk/oz1pif.htm
Ph. +45 4619 3239
Snailmail:
Peter Frenning
Ternevej 23
DK-4130 Viby Sj.
Denmark
***********************************
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|