Most of these problems are in the COM port of your computer. Are you using
an RS-232 serial port on the computer or serial-to-USB adaptor? In any
case, check your Device Manager, make sure you have the right COM port
selected, and set it to 57,600 8-N-1. Re-boot everything and start over.
----- Original Message -----
From: "dbp tds.net" <email@example.com>
To: "Tentec reflector" <firstname.lastname@example.org>
Sent: Sunday, April 05, 2009 10:13 AM
Subject: [TenTec] ORION II latest version 2.04 failure to load
> Not having any success loading the new version 2.04XL for the ORION II. It
> will get to load to line 10 of 5012 and halt at that point.
> Currently I'm running version 2.039 and DSP2.016b14 so I think the loader
> program is up to date.
> I have been off line so would have missed updates since early March.
> Any suggestions?
> TenTec mailing list
TenTec mailing list