Oh yes, isolation is best, that is until lest we forget.
I also agree that guy wires should have a driven ground outside of the
anchor base and a separate #6 connected to all of the guys above the
turnbuckle. And guy wires should have a bond between the tower and the guy
at the tower attachment point. This is specially true if one wants to avoid
VHF and UHF IM problems.
----- Original Message -----
From: "Dr. Gerald N. Johnson" <email@example.com>
Sent: Monday, April 06, 2009 11:42 AM
Subject: Re: [TenTec] RF Ground
> On Mon, 2009-04-06 at 06:05 -0400, Gary Smith wrote:
>> Hi Bob,
>> My antennae use the same radial field of 60 or so 130' radials. The
>> radial plate is 360' from the house. The only connection between the
>> house and the radial field is via the coax shield. Are you suggesting
>> I run a length of additional wire from one of the radials to the
>> grounding point of the service entrance ground rod?
>> Gary, KA1J
> I prefer to isolate the tower from the house wiring during
> thunderstorms. When lightning hits with a few kilo amps and the house
> wiring is 12 gauge, even a small fraction of those few kilo amps wipes
> out house ground wires, radios, and appliances. So I keep those ground
> separated unless I need to connect them for coax fed antennas or finding
> RF on my key or microphone.
> I also prefer that the tower guys not be insulated to spread tower
> grounding over a much larger area. Sure for RF the ground field and the
> house should be interconnected and the guy wires not resonant, but to
> handle kilo amps (and my tower get direct hits being out in the country
> and taller than anything in nearly a mile in all directions), I WANT all
> those guy wire grounds isolated from the house wiring.
> 73, Jerry, K0CQ
> TenTec mailing list
TenTec mailing list