TenTec
[Top] [All Lists]

Re: [TenTec] Aux I/O connection

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Aux I/O connection
From: "Jack B. Friend" <jfriend31@comcast.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 18 Apr 2009 18:59:22 -0600
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
John, if you look at your manual and the I/O cable that comes with the
Orion, you will note that cable has red, white, black and yellow ends.
all are phono plugs. 
get a 1/8" adapter for each to plug into the sound card on your
computer.
white from the Orion goes to BLUE on your sound card.
yellow from the Orion goes to PINK on your sound card.

use stereo plugs for the sound card.

jack ak7o


the white from your I/O (from the Orion) goes to the On Sat, 2009-04-18
at 20:48 -0400, John B. Egger wrote:
> I'm hoping to get started on digital modes (other than CW, that is) but 
> face a problem right at the start. My computer has "Speaker out" (used 
> for its speakers), "Line In," and "Mic In" jacks (all 1/8" stereo). The 
> auxiliary cable's white phono plug is for "Line In", but I have no "line 
> out" on my computer. Does it go (through a phono-to-stereo-plug adapter) 
> to the computer's "Line In" jack?
> 
> Obviously I'm on the ground floor with this. Other connections, and 
> software (I have Fldigi, Xlog, and Twpsk) issues will come later.
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>