[Top] [All Lists]

Re: [TenTec] Triton PTO kit same as Corsair II?

To: <geraldj@storm.weather.net>, "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Triton PTO kit same as Corsair II?
From: "Mike Hyder, N4NT" <Mike_N4NT@embarqmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 22 Apr 2009 13:38:42 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
The tuning knob turns a shaft coupled to a thin, brass shaft by a vernier 
means.  The thin shaft extends to the back of the PTO unit.  That shaft has 
large threads which pass through and move the piston into and out of the 
coil.  The 580, 579 and 2510 PTO shafts have left-hand threads while those 
of the other rigs have a right-hand thread.  I just dug several out of my 
closet and gave them an eyeball examination.  Though my memory is dim, my 
eyesight is OK.

Although the piston is not included with the rebuild kit, the shaft does 
come with each kit and its threads must match that of the piston.

Mike N4NT

----- Original Message ----- 
From: "Dr. Gerald N. Johnson" <geraldj@storm.weather.net>
To: <tentec@contesting.com>
Sent: Wednesday, April 22, 2009 5:39 AM
Subject: Re: [TenTec] Triton PTO kit same as Corsair II?

> On Wed, 2009-04-22 at 00:04 -0400, Mike Hyder, N4NT wrote:
>> I was mistaken.  The rigs with the left hand thread shafts are the 580, 
>> the
>> 579 and the 2510.
>> 73, Mike N4NT
> And since the threaded shaft and pistol are not part of the rebuilding
> kit, it doesn't matter which hand the thread is if all the other parts
> are the same. I just checked my kit and those two parts are not part of
> the rebuilding kit.
> 73, Jerry, K0CQ

TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>