Hi Ralph....thanks for the info..it does work, but I was disappointed in the
smeter not be very active...a local bc station was only s3...de Rick NQ4I
On Mon, Apr 27, 2009 at 12:11 PM, Ralph Matheny <firstname.lastname@example.org>wrote:
> You can select BC freqs on either VFO, IF the VFO is not assigned to the
> transmitter. This is true on the ver of firmware I have (1.372, I think)
> but may be different on other versions.
> So--to answer the original question, assign VFO A (or B) to the SUB rx,
> making sure that the chosen VFO is NOT assigned to transmit. Then depress
> VFO A enter, (freq display clears) enter "4455.9" (or whatever), and
> depress VFO A enter again. You should be tuned to listen on 4455.9Khz.
> Only the sub receiver will tune very far beyond the ham bands. After the
> overlap (allowed for MARS Freqs) the software blocks your "adventure".
> Ralph Matheny
> 207 Gibbons Place
> Marietta Ohio 45750
> TenTec mailing list
TenTec mailing list