[Top] [All Lists]

[TenTec] Orion-1 problem

To: tentec@contesting.com
Subject: [TenTec] Orion-1 problem
From: bill ogden <billogden@optonline.net>
Reply-to: bill ogden <billogden@optonline.net>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 26 Jun 2009 12:45:01 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
I had many suggestions to reseat the cables.  I did this, including a slight 
twist on all the small coax cables on the top chassis, the bottom chassis, and 
the front panel.  Also tried flexing the panel (just a little bit).  Absolutely 
no reaction.

Sub receiver works well.  Main receiver acts as if no antenna is attached, BUT 
the sweep (with the latest beta firmware) indicates normal signals so signals 
must be entering the main receiver. Transmitter is OK.  (Problem started before 
installing the latest firmware, so that is not the problem.)

Master reset did not solve the problem, either.  


Bill - W2WO
TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>