[Top] [All Lists]

Re: [TenTec] Omni VI plus receiver problem

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Omni VI plus receiver problem
From: Jim Goudie <JAGoudie@comcast.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 26 Jun 2009 19:06:28 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>

Is the Pass-band tuning operating normally?

I had some flaky problems that were caused by dirty connectors 
between boards & controls (display and PBT in particular).  Someone 
on the list recommended "exercising" all the connectors.  So, I did 
that and tried to clean the contacts, at the same time.  It takes 
some patience and a gentle touch, I think...  but a general clean up 
of the connectors may be worth a try... even as preventive 
maintenance if they haven't been done in a while.

All that is imho. :-)

Jim, AF3Z

At 6/27/2009 12:17 AM, you wrote:
>My receiver emits a wind tunnel like rushing sound and tone on all 
>frequencies when rf gain is at or near max.? it just started doing 
>this after working flawlessly.? any suggestions would be appreciated.
>73 de John, k5see
>TenTec mailing list
TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>