[Top] [All Lists]

[TenTec] Ten-tec 962 ps problem problem

To: tentec@contesting.com
Subject: [TenTec] Ten-tec 962 ps problem problem
From: Phillip Zminda <phil-z@comcast.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 6 Sep 2009 20:54:02 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Over the weekend my 962 supply for my Omni VI blew the ac fuse every  
time I turned it on. I expected that the bridge rectifier could be the  
problem. When I opened it up, I found that the bolt holding down the  
filter board was loose leaving the bridge without a heat sink. I  
haven't  unsoldered the bridge but expect that it's the likely  
problem. Has anyone else experienced blown fuse problems with the 962?  
Also, is this a part I can but from Ten-Tec without buying an entire  
board? If not, does anyone know the specs for a direct replacement?  
Since it's a holiday weekend, there's no chance to call Ten-Tec until  

For me, if anything every breaks around the house, it's on a holiday.  
I've had furnaces go out, dishwashers, stoves and any other number of  
appliances go out on Christmas, July 4 or Memorial Day. This must be  
my 2009 holiday breakdown.

Thanks for any input.

Phil N3ZP
TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>