I might suggest you try a 4.7 K resistor from pin 2 to the mic side. Also a 1
mFd capacitor between the lead and pin 8 on the mic connector.
I think this will give you the correct voltage, but the DC is blocked from the
radio side of the cap. Mic gain might need to be reduced to around 7-10
percent to avoid overdriving.
Others have suggested a 6.8K or even a 10K resistor on pin 2.
========== Happy trails - James - K8JHR ==============
> ------------Original Message------------
> From: "Peter Frenning [OZ1PIF]" <firstname.lastname@example.org>
> Subject: [TenTec] Electret Microphone "plopping/clicking"
> I bias the electret element from the voltage present on Pin2 through a
> 2.2KOhm resistor,
TenTec mailing list