I've rebuilt several Corsair II PTOs and I don't recall there being a
second pin. Could it simply be a spare which TT ships because it's a
part that is easily lost?
Andrew Moore wrote:
> Two small pins (about 1/4 inch long) were supplied with the PTO kit. One is
> the stop pin that goes through the PTO tuning shaft's threads to stop the
> PTO turning and going too far into the PTO coil. I've installed that and it
> works fine.
> The other appears to go through the "core drive rod" (part 90202), but it
> goes in only so far (about a millimeter) and stops, I'm assuming because
> it's hitting the tuning shaft (90201) which isn't drilled to accept a pin --
> it's solid. However it looks as though it could travel about another 1 mm
> before hitting the tuning shaft. Maybe there's another axis, drilled to
> accept pin, that the CDR is supposed to lock to...? ...which might be why
> the instructions said to take note of the position before removing the pin
> Any help would be appreciated. I've lost the disassembly photos that I took
> when I began this project.
> I have a photo of the (started) pin I can show for context.
> --Andrew, NV1B
> TenTec mailing list
TenTec mailing list