I don't know which specific models of filters you have, but I can tell you
that in many cases filters differ in the number of "poles" they implement.
An example being replacing the 4 pole 2.4 khz filter in some ten tec models
with an 8 pole aftermarket filter. It gives you sharper, and deeper,
skirts, without much insertion loss. The result ? In the heat of battle,
with strong signals climbing in very close to you, the deeper skirts will
allow you to operate better through a qrm rich environment. Otherwise, you
will notice little change. If thats the kind of filters you have, it would
explain their purpose.
73 de Gary, AA2IZ
----- Original Message -----
From: "Brian Pepperdine" <email@example.com>
Sent: Tuesday, September 22, 2009 4:06 PM
Subject: [TenTec] OMNI VI +ver 3 info?
> Hello. I recently bought a Factory updated OMNI VI+ ver. 3.
> Nice. But the addendum sheets to the upgrade don't tell the whole story.
> Does anyone have or know of where the info is to describe the new button
> functions that have been substituted in for the original buttons on the
> right? I am not sure of all the functions (some don't seem to do anything
> Also, this rig came with both roofing filter slots filled with
> International Crystal 2.4 filters. I am mystified as to what they do..
> either one of them N1 or N2 don't seem to do much.... do I have to be in
> the heat of contest battle with warriors close on all sides to notice any
> In any case, the normal 2.4 stock IF seems fine and if it suited me
> better maybe I should sell those filters and put in 500 hz CW filters or
> go it alone with the standard IF xtal filters (it has the 1.8 and 500 in
> it already)...?
> Any info appreciated.
> Brien Pepperdine
> TenTec mailing list
TenTec mailing list