[Top] [All Lists]

Re: [TenTec] Omni 5 Feedback

To: geraldj@weather.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Omni 5 Feedback
From: Bwana Bob <wb2vuf@gti.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 29 Sep 2009 22:31:59 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
I've had that on my Paragon, but only with the internal speaker. In my 
case, it was caused by a little resistance in the shield lead of the 
audio output.


                                                Bob WB2VUF

Dr. Gerald N. Johnson wrote:
> On Mon, 2009-09-28 at 15:15 -0400, Howell, D. Haney wrote:
>> My trusty Omni 5 has been under wraps for a few months.  When I fired it up
>> recently I experienced motorboating and rumbling feedback though the
>> speaker.  As the old hamfest saw goes, it was working fine the last time I
>> used it!  Any suggestions where to start troubleshooting?
>> Haney
>> k2xn
> Usually motor boating and rumbling feed back are a sign that the power
> supply bypass electrolytics have gone nearly open or have gone way down
> in value. That's not only the main power supply but the various supply
> voltage busses on the board.
> But for a first step, to make sure the board grounds are good, tighten
> all the PC board mounting screws. Then in Tentecs wiggle the cable
> connectors. Or pull them off and apply a tiny bit of DeoxIT to each pin.
> 73, Jerry, K0CQ
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>