You need 2 audio type cables to connect between the amp and the Orion.
1) Connect the Orion TXOUT to the KEY IN connection on the amp.
2) Connect the Orion TXEN to the KEY OUT connection on the amp.
3) Run a coaxial RG8 type connection from the antenna connection
connection
on the Orion to the RF input connection on the amp.
4) Connect your antenna to the amp RF out antenna connection.
5) In the Orion II menu, turn on TX Loop.
That should do it.
Carl Moreschi N4PY
121 Little Bell Drive
Hays, NC 28635
www.n4py.com
----- Original Message -----
From: "John Molenda" <brazos@rochester.rr.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, October 15, 2009 8:12 PM
Subject: [TenTec] need help
Hello gang , This is only my 2nd experience with using an amp . I would
like to know how to hook up my Ten Tec Orion II to my Titan 425 amp . I
do want the amp and radio to operate qsk. I have all the proper 220
connections made as well as two (don't know how many I will need ) audio
cables to connect between the rig and amp. The manuals for the amp and
radio are dry and long to getting to the point. How many connections need
to be made between the rig and amp ? How about the menus on the radio I
know to switch the key loop 1 to on and disable the internal tuner .
thanks for the help . Does anyone know if a video is available for this
:>) I am so lame when it comes to this stuff. thanks to all who respond
. John kb2huk
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec