Re: [TenTec] 962 Power Supply Schematic/Manual

[John - K4WJ <k4wjfoc1749@wildblue.net>]

I have a 962 that I purchased when I bought my Omni VI Plus from TenTec. 
They were both brand new but the 962 didn't last a week before I had to 
return it for repairs. Fortunately I had the PS from my Omni C that I used 
to get back on the air with the Omni VI Plus.
Last October I sent the 962 back to TenTec and they replaced the two 2N5301s 
with 2N5886Gs.
The 962 runs a lot hotter than my old 961. When I have the Omni VI Plus 
turned on the heat sink on the 962 gets kind of hot. I've read messages on 
this reflector that said this is normal for this power supply.
When the rig is off and the PS is turned on the heat sink stays nice and 
cool.
My scanner's bulb burned out or I would scan the manual and send it to the 
initiator of this thread. I'll try to find someone to scan it for me. 
However I'm in a rural area and it may take some time before I get it 
scanned.
73..de John/K4WJ

----- Original Message ----- 
From: "Rick - NJ0IP / DJ0IP" <Rick@DJ0IP.de>
To: <geraldj@weather.net>; "'Discussion of Ten-Tec Equipment'" 
<tentec@contesting.com>
Sent: Sunday, July 04, 2010 10:13 AM
Subject: Re: [TenTec] 962 Power Supply Schematic/Manual


> I thought I scanned the 961 and the 962, but I couldn't find the either.
> I owned both at the same time years ago and as someone pointed out here
> recently, the difference was in the polarity being regulated - but I can't
> remember which one was which.
>
> There really never was a manual.  Just a couple of loose pages.
>
> Hopefully someone reading this will have the schematics of either or both
> and scan them now and distribute.
>
> 73
> Rick
>
>
> -----Original Message-----
> From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
> On Behalf Of Dr. Gerald N. Johnson
> Sent: Sunday, July 04, 2010 12:06 AM
> To: tentec@contesting.com
> Subject: Re: [TenTec] 962 Power Supply Schematic/Manual
>
> Trouble is Tentec doesn't admit there is a manual for that supply on
> line. They do admit the power supply exists in other manuals like that
> for the Paragon II and Omni VI. The other typical on line sources of
> manuals don't have one, not even for a price. The 960 is linear, the 963
> is definitely switching, I can't tell for the 962. The majority of
> google hits came up for sellers of the Paragon II or Omni VI with 962 PS
> and manual over the past decade. One discussion on a forum like this
> revolved around the diode bridge that had ratings like that for a linear
> supply and 6 years ago someone had a scanned manual and schematic.
>
> 73, Jerry, K0CQ
>
> On 7/3/2010 11:06 PM, Rick - NJ0IP / DJ0IP wrote:
> > Contact Ten-Tec on Tuesday.
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec