[Top] [All Lists]

[TenTec] Omni VII - DXLab Commander, Bandspread, comm problem

To: "DXLab Group" <dxlab@yahoogroups.com>
Subject: [TenTec] Omni VII - DXLab Commander, Bandspread, comm problem
From: "CSM\(r\) Gary Huber" <glhuber@msn.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 10 Jul 2010 12:00:12 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
I have been experiencing the following problem with my OMNI VII only while 
using the PC's mousewheel to QSY the O7 while the mouse is on the Bandspread 
screen of Commander IV:

No matter what band or mode the radio is in, after 1 click or 100 clicks of the 
mouse wheel, the O7 QSYs to 54 MHz or in some cases 100 Hz (upper and lower 
frequency limits).

All other Commander functions (and those of the other DXLab Suite modules) 
operate the O7 as they should. 

Occasionally (infrequently) Bandspread and the mousewheel QSY of the O7 is 
absolutely unbreakable. When this is the case, if the O7 is turned off, the 
Bandspread is unresponsive (grays out) until the O7 is turned back on. 

MSComm32 is suspect, but I have no way of testing it. I believe this DLL may 
not be initiating properly for the 57600 data rate in Bandspread. See 
http://msdn.microsoft.com/en-us/library/aa259393(VS.60).aspx for details. 

Anyone else have the problem? Do you have a fix or work around?

Best regards,

CSM(r) Gary Huber - AB9M
9679 Heron Bay Rd
Bloomington, IL 61705
TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>
  • [TenTec] Omni VII - DXLab Commander, Bandspread, comm problem, CSM\(r\) Gary Huber <=