Thanks for the reply Carl.
Well it works MUCH better with Version 2 of the firmware. So you may well be
right. I loaded Version 2.063Xg and did a RAM CLEAR and followed that with a
Master Reset and it seems to function quite nicely with the SP OFF!
Others seem to NOT have the same problem running 1.373b5 that I do? So I guess
I'll live with it and just wait until the next new and improved version 2.xxx
hits the Ten-Tec site.
Again, thanks for the reply.
To: "Discussion of Ten-Tec Equipment" <firstname.lastname@example.org>
Subject: Re: [TenTec] Orion Monitor Problem
From: "N4PY2" <email@example.com>
Date: Mon, 19 Jul 2010 20:52:39 -0400
What happens with version 2 Orion firmware? I think the entire path for
monitor is in the firmware. This could be a bug back in 1.373b5.
Carl Moreschi N4PY
121 Little Bell Drive
Hays, NC 28635
----- Original Message -----
From: "Rick W" <firstname.lastname@example.org>
To: "Ten-Tec Reflector" <email@example.com>
Sent: Monday, July 19, 2010 8:44 PM
Subject: [TenTec] Orion Monitor Problem
>I rarely use the MON function on my Orion (565) but decided to give it a
> recently. Well it doesn't seem to be working the way it should. Here's
> 1) firmware 1.373b5
> 2) MON level at 100%
> 3) SP (speech processor) off -- more on this.
> 4) earphones plugged in
> 5) Ten-Tec hand mic
> 6) No external Orion software involved
> With this set-up I DO NOT hear the monitored signal in the earphones? I
> tried a
> different set of earphones and a different microphone. Still nothing.
> Now if I turn ON the SP the monitored audio increases as I increase the SP
> strength. It's very light at 1 and quite audible at 6??
> I have done a RAM CLEAR and MASTER RESET but nothing has changed. MON
> well in RTTY (FSK) mode and AM? It's not great in either SSB or FM?
> It is my understanding that the MON is controlled in firmware. So looking
> how it is controlled on the schematics is not going to be the answer. So
> pretty well at a loss.
> How does the microphone audio make it to the earphones in the MON mode?
> What is
> the path and where do I start my troubleshooting?
> Thoughts appreciated! Thanks!
> Website: http://www.ve7tk.com
TenTec mailing list