TenTec
[Top] [All Lists]

Re: [TenTec] Omni V receive problems

To: tentec@contesting.com
Subject: Re: [TenTec] Omni V receive problems
From: "Dr. Gerald N. Johnson" <geraldj@weather.net>
Reply-to: geraldj@weather.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 05 Sep 2010 17:09:52 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Two solutions. A can of freeze mist and a hair dryer, or a shipping box 
to Tennessee.

Its almost sure to be heat sensitive so heat and cool a board at a time 
until you find the one that has effect, then heat and cool smaller and 
smaller segments of that board until you get it down to the part. Could 
easily be a solder problem or a breaking connection inside a part.

You could also shotgun cleaning all the cable and card edge connections 
with Deoxit by Cramolin.

73, Jerry, K0CQ

On 9/5/2010 4:40 PM, Scott Sheppard wrote:
> Lately my omni V has been acting up. When I first power up there is little or 
> no receive--if there is, its often some odd ball shortwave freq. Then, as it 
> warms up, it tunes to the correct freq as displayed, but the audio is very 
> garbled and distorted. After about 40 min (warmed up) it often clears up and 
> acts normal. It has also gone back to being garbled after an hour or so even 
> once it had 'corrected itself'. It would seem its just not receive as during 
> one qso I was told my audio had become distorted--and the receive had become 
> distorted again as well.
>
> Would appreciate anyone who may have had similar problems/fixes providing 
> input.
>
> scott  VA3IED
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>