Re: [TenTec] Adding Power Poles to an Orion

["Denton" <denton@oregontrail.net>]

A subnote...
After installing the Powerpoles on my Orion I, I ran a key down 100 percent 
out to dummy load test...I noticed that the little 25 amp blade fuse and its 
holder get kinda warm to the touch...anything to worry about? I used to run 
a lot of rtty many years ago and can remember having to beef up the dc 
connector in my Delta because of current draw.
----- Original Message ----- 
From: "Denton" <denton@oregontrail.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, October 24, 2010 5:39 PM
Subject: Re: [TenTec] Adding Power Poles to an Orion


> I do this to all my Ten Tecs...was an easy mod on my Orion I...did my Omni
> VII some time ago.
> ----- Original Message ----- 
> From: "Fernando" <n2fq@sbcglobal.net>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Sunday, October 24, 2010 12:15 PM
> Subject: [TenTec] Adding Power Poles to an Orion
>
>
> > Hello.
> >
> > I just completed adding power poles to my Orion.
> >
> > It's isn't difficult if anyone was contemplating doing it.
> >
> > Here are some photos and details on request.
> >
> > <http://pages.sbcglobal.net/n2fq/>
> >
> > enjoy
> >
> > 73 Fernando N2FQ/6
> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec