The thing is, if the radio is transmitting on the wrong freq, you can't use
a dummy load and tell by looking at the SWR.
Phil C. Sr.
k4dpk
----- Original Message -----
From: "Ken Brown" <ken.d.brown@hawaiiantel.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Saturday, November 27, 2010 5:36 PM
Subject: Re: [TenTec] omni 6+/ power issue
>
>> The tuner confuses the issue a bit, but are the tuner settings where they
>> normally are for 20m?
>>
>>
> If you don't have a good 50 ohm non-inductive termination (dummy load)
> you should get one. It really helps to simplify the system when
> troubleshooting. With a standard 50 ohm termination and a power
> monitoring device (doesn't have to be a real good one, just one that you
> can use as a comparison from other rigs and bands) you will be able to
> determine whether it is a problem with the rig and not the load.
>
> DE N6KB
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|