Jerry, thanks for the clarity on the ground.
I wasn't sure if the ground stake for the termination was considered to be
an RF or DC ground.
As for the performance of the Beverage, with all due respect, the Beverage
is an outstanding antenna, not a rotten antenna.
I guess I have about 200 co-members of our contest club who have witnessed
this to, used it time and again.
On our larger contest DX-peditions we always put up at least 4 beverages.
They are fed by a splitter which enables multiple receivers to use the same
beverage, even if they are on different bands.
We hear stuff on the beverage that we can't hear with the verticals, dipoles
I have seen and done this countless times, so I'm not sure why you think
it's a rotten antenna.
For home use, many of our guys use the K9AY "terminated" loop.
Its performance is inferior to a beverage, but on a small city lot, it also
enables hearing weak signals on the low bands which you do not pick up on
the transmit antenna.
Perhaps someone will argue that the resistor introduces some additional
loss, even on receive, but that is a mute point. Without it you would not
have an antenna whose "signal to noise ratio" on that band at that location
is superior to anything else you have.
I'm curious why you said the Beverage is rotten ???
From: email@example.com [mailto:firstname.lastname@example.org]
On Behalf Of Dr. Gerald N. Johnson
Sent: Friday, December 03, 2010 5:06 PM
Subject: Re: [TenTec] was OT: Indoor Antenna: re B&W type terminated dipoles
The low long wire is a Beverage and the termination is for RF. It works
down to DC as does the antenna though it looses its directivity when it
gets short in wavelengths. Overall its rotten at receiving so often
needs its own preamp, but its also more rotten at receiving noise from
other than its preferred direction.
73, Jerry, K0CQ
On 12/3/2010 4:53 PM, Rick - NJ0IP / DJ0IP wrote:
> You're jumping to conclusions, Stuart.
> I have a 65 ft. vertical for transmitting.
> I was looking for a receive antenna for 160 and 80m.
> (My Eagle already has the mod with the 2x Phono jacks so I can use a
> separate RX ant.).
> The Ewe looks interesting.
> With a resistor, it has front to back.
> Without the resistor it does not.
> The resistor on the far end goes from the antenna to a ground stake.
> I'm not wasting any power.
> So, is this an RF ground or a DC ground? Or both?
> I don't know.
> I'm just asking.
TenTec mailing list
TenTec mailing list