[Top] [All Lists]

Re: [TenTec] TITAN 425 PS maintenance

To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] TITAN 425 PS maintenance
From: "Don Jones" <ko7i@comcast.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 4 Dec 2010 10:03:08 -0800
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Ditto what Jerry said. 
To do such a mod without a change to the output tank circuit is reckless.
Nice power supply redesign effort but unfortunately this job is only half
done (or baked). Hams have a responsibility to transmit a clean signal that
is not a source of harmful interfere.
I would like to see the two tone harmonics content of the transmitted signal
with pulse rated tubes. I have heard that it requires great RF design skills
to get a pulse rated tube to operate cleanly when transmitting a SSB signal.
But then no one would over-drive their transmitter on our ham bands to break
a DX pile up... no they wouldn't do that...
Then there is the issue of Radiated RF Field strengths and safety...
3500W vs. 1500W = +3.68 gain (or 1/2 a "S" unit).
I fail to see a true value added "return on investment" on this one.

Don Jones KO7i
Arlington, WA 

-----Original Message-----
From: Dr. Gerald N. Johnson [mailto:geraldj@weather.net] 
Sent: Friday, December 03, 2010 1:22 PM
To: tentec@contesting.com
Subject: Re: [TenTec] TITAN 425 PS maintenance

Now there's a slippery slope. Raising the plate voltage and lowering the 
current means a higher load impedance, and so to do it properly means 
redesigning the PI-L network for that higher impedance. 
73, Jerry, K0CQ

TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>