R-35 is, of course, on the Corsair II.
Phil C. Sr.
----- Original Message -----
From: "Phil Chambley Sr." <email@example.com>
To: <firstname.lastname@example.org>; "Discussion of Ten-Tec Equipment"
Sent: Saturday, December 25, 2010 9:40 AM
Subject: Re: [TenTec] non qsk amp
> On the 544, I'd change R-11 from 680 ohms to 4700 ohms, or C-3 from 33 to
> ufd. Not both.
> As Jerry said, on R-35, you can cut the ground foil run and bridge the gap
> with a 4700 ohm.
> These resistors can be 1/4 watt.
> That should get you close.
> Merry Christmas everyone!
> Phil C. Sr.
> ----- Original Message -----
> From: "Dr. Gerald N. Johnson" <email@example.com>
> To: <firstname.lastname@example.org>
> Sent: Friday, December 24, 2010 10:06 PM
> Subject: Re: [TenTec] non qsk amp
>> On the Corsair II control board, it looks like increase C6 or R12
>> preferably R35 better than R12. C6 is 33 mfd, R35 is a 10K pot. Don't
>> have anything on hand for the 544, but its probably similar.
>> 73, Jerry, K0CQ
>> On 12/24/2010 8:19 PM, email@example.com wrote:
>>> hi, using 544, corsair II - want to key an old amp - NCL2000 - but the
>>> delay adjustment for CW in the rigs has narrow range - I would like to
>>> slow the relay down a bit more..... suggestions to change circuitry for
>>> delay of relay??
>>> dave nd0cw
>> TenTec mailing list
> TenTec mailing list
TenTec mailing list